Use and Care Manual
Questions? Call Toll Free at 1-800-737-2112 Copyright © 2017 MAT Engine Technologies, LLC
EN - 2
Safety Definitions
• Save all instructions
Safety Warning Symbols:
DANGER
Indicates an imminently hazardous situation which, if not avoided, will result in death or
serious injury.
WARNING
Indicates a potentially hazardous situation which, if not avoided, could result in death or
serious injury.
CAUTION
Indicates a potentially hazardous situation which, if not avoided, may result in minor or
moderate injury.
NOTICE
Indicates a practice not related to personal injury which, if not avoided, may result in
property damage.
The information listed below should be read and understood by the operator. We utilize the symbols below to allow
the reader to recognize important information about their safety.
Safety Alert Symbols:
Control and Operating Symbols:
The following symbols can be found on your Auger. Carefully read and understand their meaning.
Choke Control:
Cold Start
Run/Warm Start
Fuel Primer:
Press 6 times.
Fuel Mixture
50:1
Unleaded Gas: 2 Cycle Oil
Caution: Do Not Use Gas
Mix with More Than 10%
Methanol or Ethanol
Fuel Mixture:
50:1
(Unleaded Gas : 2 Cycle Oil)
ON
OFF
Ignition Switch:
ON
OFF
Look for this symbol to point out important safety precautions. It means: Attention! Become
Alert! Your Safety Is Involved.
Read, understand and follow operator’s manual before operating this machine. Failure to
follow directions could result in serious injury.
Extremely hot surface. Do not touch a hot muffler, gear box or cylinder, you may get burned.
These parts get extremely hot from operation and remain hot for a short time after the unit is
turned off.