Use and Care Manual

ENG - 16

Maintenance

• Save all instructions

• Before performing maintenance, the log splitter must be placed in maintenance mode. Turn off the engine and move

the control lever forward and backwards to relieve the hydraulic pressure.

• After performing any maintenance, make sure all guards, shields and safety features are put back in place before

operating the log splitter.

• Before operating make sure the tires have the recommended tire pressure.

• Grease axle and wheel bearing annually.

• Periodically check all fasteners and hoses for tightness and leaks.

• Annually clean and lightly lubricate all moving parts or when needed.

• Use a glossy enamel spray paint to touch up scratched or worn painted metal surfaces.

What When Method

Hoses Each Use

Inspect hoses for exposed wire mesh and leaks. Replace all worn or damaged

hoses before starting the engine.

Hydraulic

Fittings

Each Use

Inspect ttings for cracks and leaks. Replace all damaged ttings before start-

ing the engine.

Nuts and Bolts Each Use Check for loose bolts, tighten before operating.

Beam Each Use Apply grease to beam surface.

Moving Parts Each Use Clear debris from log splitter.

Refer to the Engine Owner’s Manual for engine maintenance.

If a part needs replacement, only use GENUINE parts that meet the manufacturer’s specications. Replacement parts that

do not meet specications may result in a safety hazard or poor operations.

STORAGE

• Before storing make sure the log splitter is clean and dry.

• Store equipment in a clean, dry area. Store machine away from sparks, open ames, pilot lights, heat and

other ignition sources.

• Lightly lubricate all log splitter surfaces and moving parts to prevent rust(see maintenance).

• Store indoors or protected area during severe weather and winter months.

• Refer to Engine Owner’s Manual for correct engine storage instructions. It is especially important to remove fuel

from the engine when the unit is to be stored for an extended period.

NOTICE