Use and Care Manual

Drive Safety Control Levers

Operation (Continued)

• Save all instructions

CAUTION

Do not operate both “FORWARD” and “REVERSE” drive

safety control levers at the same time.

This information is provided here only to introduce the

controls. Do not start the engine at this time. Starting and

operating instructions are given on page 11. Please read

this section and all operating and safety instructions before

starting your tiller.

As a safety precaution, the drive safety control levers will

not lock in the forward or reverse position.

WARNING

Do not x the forward or reverse drive levers in the drive

position by any other means than manually using your right

hand. Do not tie or otherwise secure the levers in the drive

position.

To stop the wheels and tines at any time release the drive

safety control levers.

Forward Lever (See Figure 9)

Engages wheels and tines into forward. Pushing down

the drive safety control lever (FORWARD) toward the

handlebar engages the wheels and tines. Releasing the

lever stops the wheels and tines and brings the tiller to a

complete stop.

Reverse Lever (See Figure 10)

Engages wheels and tines into reverse.

Pulling the drive safety control lever (REVERSE) toward

the handlebar reverses the tiller. Releasing the lever stops

the wheels and tines.

Forward Lever

Engaged

Figure 9

Reverse Lever

Engaged

Reverse Lever

Figure 10