Instructions / Assembly

Engine Oil Change Instructions

REAR TINE ROTARY TILLER

Questions on this procedure or anything related to your tiller?

Feel free to contact our Product Services Group at 1-800-737-2112.

Model Nos. PRTT212

BEFORE STARTING THIS SERVICE

PROCEDURE READ THROUGH THE

INSTRUCTIONS COMPLETELY.

Follow the steps below to prevent accidental starting and injury.

1. Start the engine and allow it to run for approximately 3 minutes, until it is warm.

2. Turn off the engine (place the On/Off Switch in the “Off” position)

3. Take care throughout this service procedure as some surfaces of the engine and exhaust will be hot.

4. Disconnect the spark plug wire and secure it away from the spark plug. This will prevent accidental starting.

Tools Required:

- 12mm Socket and Ratchet or 12mm Wrench

- Oil Drain Pan or equivalent

- Old Newspapers or Drop Cloth

- Rags

- Small Funnel

PAGE 1
Model Nos. PRTT212 Engine Oil Change Instructions REAR TINE ROTARY TILLER BEFORE STARTING THIS SERVICE PROCEDURE READ THROUGH THE INSTRUCTIONS COMPLETELY. Follow the steps below to prevent accidental starting and injury. 1. 2. 3. 4. Start the engine and allow it to run for approximately 3 minutes, until it is warm. Turn off the engine (place the On/Off Switch in the “Off” position) Take care throughout this service procedure as some surfaces of the engine and exhaust will be hot.
PAGE 2
Locating the engine oil drain plug: • When standing in “operator’s position” (at the handles of the tiller facing the engine), the engine oil drain plug is located on the left side of the engine just above the frame. See images below. Standing in “Operator’s Position” Engine Oil Drain Plug Left Side of Tiller Engine Oil Fill Cap/Dipstick 1. Place some old newspapers (several layers spread out) under the tiller. 2. Using a rag, clean the areas around the drain plug and oil fill cap/dipstick.