User Manual
Table Of Contents
- 15S, 15HH Planer
- Warranty and Service
- Table of Contents
- Warnings
- Features
- Specifications
- Unpacking
- Installation and Assembly
- Adjustments
- Belt Tension
- Pulley Alignment
- Table Rollers
- Cutterhead
- Replacing Knives (Model 15S only)
- Replacing or Rotating Knife Inserts (Model 15HH only)
- Work Table Parallel to Cutterhead
- Know the Transmitting Rollers of Your Planer
- Anti-Kickback Fingers
- Infeed and Outfeed Roller Spring Tension
- Height of Infeed Roller, Chipbreaker and Outfeed Roller
- Outfeed Roller Height
- Infeed Roller Height
- Chipbreaker Height
- Chip Deflector
- Feed Speed Control
- Stock Return Rollers
- Depth of Cut
- Maintenance
- Lubrication
- Functions of the Digital Scale (Model 15S only)
- Troubleshooting
- Switch Lock
- Optional Accessories
- Replacement Parts
- Electrical Connections Single Phase, 230 Volt
- Preventive Maintenance
39
Preventive Maintenance
Checklist for Model 15S and 15HH Planers
[ ] Work area around machine marked off clearly.
[ ] Non-skid floor strips in area where operator normally stands.
[ ] Inspect entire machine for loose bolts, nuts, screws. Tighten and replace as necessary.
[ ] Clean table and cutterhead area, removing sawdust and chips with a soft bristle brush. Remove
gum and pitch with oven cleaner.
[ ] Lubricate appropriate places with a good grade non-hardening grease.
[ ] Clean table surface. If rusted, use paste mixture of household ammonia, a good commercial
detergent and 000 steel wool. Wash surface down with hot, soapy water, rinse and dry
thoroughly. Coat surface with talcum powder, rubbing briskly into surface with a clean blackboard
eraser.
[ ] Check blade condition; should be sharp and free of nicks or grooves.
[ ] Check belt condition. Replace as needed. Dress with belt dressing. Check belt tension.
[ ] Check motor for loose wiring and sawdust congestion, pulleys tight and in line.
[ ] Check bearings. Replace any bad or suspect bearings immediately.
[ ] Check leveling of extension tables with main table.