Warranty

6.0 Unpacking

Open shipping container and check for shipping

damage. Report any damage immediately to your

distributor and shipping agent. Do not discard any

shipping material until the Lathe is assembled and

running properly.

Compare the contents of your container with the

following parts list to make sure all parts are intact.

Some parts can be found in separate boxes

packed around the Lathe. Missing parts, if any,

should be reported to your distributor. Read the

instruction manual thoroughly for assembly,

maintenance and safety instructions.

6.1 Contents of shipping container

1 Lathe Bed, with Headstock, Tailstock, & Tool

Support Base – (A)

2 Leg Assemblies – (B)

1 Guard – (C)

1 Tool Support, 14” – (D)

1 Face Plate, 3” – (E)

1 Live Center – (F)

1 Spur Center, 1” – (G)

1 Index Pin – (H)

1 Live Center Pin – (J)

1 Knockout Rod – (K)

1 Face Plate Wrench – (L)

1 Tool Caddy – (M)

4 Levelers – (N)

10 Socket Hd. Cap Screws, 3/8” x 1-1/4” – (O)

10 Lock Washers, 3/8” – (P)

8 Flat Washers, 3/8” – (R)

1 Owner's Manual (not shown)

1 Product Registration Card (not shown)

Read and understand the entire contents of this manual before attempting set-up or

operation! Failure to comply may cause serious injury.