Use and Care Manual

15
Figure 22
Vertical Alignment
4. Use the socket head screw (H, Figure 23)
located toward front of laser assembly, to
adjust verticality of laser line. Turn screw as
needed (2.5mm hex wrench), and move board
side-to-side as needed, until laser light (E)
aligns with board marking (B).
5. Adjust the other laser in the same manner.
Two parallel laser markings should look like F
and G in Figure 22. The distance between the
lines will vary with board thickness; however,
the lines must be parallel.
Figure 23
Cross Hair Alignment
6. Place board (K, Figure 24) flat on table. Do not
allow board to move from this position; use
clamps if needed. Bring the bit down until it
leaves a slight perforation in the board; then
raise it back up.
7. Use the socket head screw (I, Figure 23)
located toward back of laser assembly, to
adjust the cross hair. Turn screw as needed
until laser line (M) crosses perforation (L).
8. Adjust the other laser assembly in the same
manner until the laser lines form cross
hairs exactly over perforation in board, as
shown in Figure 24.
9. Re-check vertical alignment to ensure that the
laser lines did not shift during the procedure.
The laser is now calibrated properly and the
location of your holes can be centered at the cross
hairs for accurate drilling.
Figure 24
9.0 Operating controls
Power Indicator Light – The start switch has a
power indicator lamp which is on whenever there
is power connected to the Drill Press, not just
when the Drill Press is running.
Do not assume that no light means there is no
power to the machine. If the bulb is bad, there will
be no indication. Always check before use.
Do not rely that no light means
no power to the machine. Always check for
power first. Failure to comply may cause
serious injury.
Referring to Figure 25:
Start – Pull out on the large red switch.
Stop – Push in the red switch.
Reset – If the Drill Press should stop without the
stop button being pressed, as the result of a
tripped fuse or circuit breaker, etc., push the red
switch back in to reset it.
Safety - The switch has a safety feature that
prevents unauthorized or accidental starting of the
drill press. With switch in "off" position, slide out the
safety key (A, Figure 25). This piece must be re-
inserted before the drill press can operate.