Use and Care Manual

16
Figure 25
10.0 Operation
10.1 Installing bits
Insert bit (not provided) into chuck jaws with about
1” insertion. When using a small bit, do not insert it
so far that the jaws touch the flutes of the bit. Make
sure bit is centered in chuck before tightening
chuck. Insert chuck key into hole in side of chuck,
and turn key clockwise to tighten bit in chuck.
10.2 Positioning work piece
Whenever possible, use
clamps or work hold-downs to secure the work
piece to the table.
Always secure the work piece to prevent it being
torn from the operator’s hand. Using the column as
a work stop is not recommended; instead, use
holding devices such as clamps. When using the
table in tilted position, make sure the table is
securely tightened and the work piece is clamped
sufficiently.
For clean, splinter-free holes, place a piece of
scrap wood on the table below the work piece.
Perform operations with a minimum extension of
the quill. Adjust table position rather than using
excessive quill travel.
Feed bit into the material with only enough force to
allow the bit to work. Feeding too slowly may cause
burning of the work piece. Feeding too quickly may
cause the motor to slow and/or the bit to break.
10.3 General Inspection
Before each operation of your Model 2800B drill
press, make a habit of checking that all locking
handles, set screws, bolts, etc., are tight on the
table and head. Confirm that drill bit is securely
inserted inside chuck jaws.
Clear all items, such as tools and rags, away from
machine.
Before attempting regular work, get the feel of the
drill press by practicing on scrap material. For best
results, always use sharp bits and proper feed
rates.
10.4 Setting rotation speed
There are several factors which determine the best
speed to use in any drill press operation, such as
kind of material being worked, size of hole, type of
drill, and quality of cut desired.
A general rule of thumb is, the smaller the drill, the
greater the required RPMs. And the speed should
be faster for soft materials and slower for harder
materials.
11.0 Maintenance
Before doing maintenance on
the machine, disconnect it from electrical
supply by pulling out the plug or switching off
the main switch. Failure to comply may cause
serious injury.
After each use, clean sawdust from the table with a
brush (do not use your hands).
Periodically apply a light film of oil to the quill and
column. This will reduce wear, prevent rust and
assure ease of operation.
It is good maintenance practice to periodically
clean the pulleys with a non-penetrating lubricant,
such as WD-40
®
, wipe off any excess, then apply a
light oil to the pulley shafts. NOTE: Do not use
graphite- or silicone-based lubricants.
Apply grease to the rack on the column.
Check that bolts are tight and electrical cords are in
good condition.
Belts should be in good condition with no signs of
cracks, frays or deterioration.
Bearings on the drill press are self-contained and
permanently lubricated; no further lubrication is
needed.
Exposed metal surfaces of table and base should
be kept clean and free of rust. Protective sprays or
paste wax are available from most hardware
stores. Note: Avoid wax that contains silicone or
other synthetic ingredients; these materials can