Use and Care Manual

17
find their way into lumber and make staining and
finishing difficult.
The quill return spring should receive SAE 20 oil
once yearly. Apply the oil beneath the coil spring
cover (L, Figure 20) using a squirt can.
11.1 Belt replacement
Referring to Figures 26 and 27:
If future replacement of belts is needed, proceed
as follows:
This procedure requires
operating machine with pulley cover removed.
Keep hands away from moving belts and
pulleys.
1. Remove pulley cover using a long shaft
screwdriver.
2. Turn on drill press and increase speed (rotate
handwheel clockwise) to maximum, to bring
center pulley as far toward spindle pulley as
possible.
3. Shut off drill press and disconnect from
power.
4. Firmly squeeze center section of upper belt to
slacken tension. See Figure 26. If needed, pull
on belt away from center pulley to further
slacken.
Figure 26
5. Remove upper belt from around pulleys.
6. Reconnect to power, turn on drill press and
rotate handwheel counterclockwise until center
pulley is as close to motor pulley as possible.
See Figure 27.
Figure 27
7. Shut off drill press and disconnect from
power.
8. Remove lower belt in same manner as upper
belt.
9. Use reverse procedure to install new belts.
11.2 Lamp replacement
Referring to Figure 28:
1. To replace a lamp, use a thumbnail or flat
blade screwdriver to gently pry down the lamp
assembly (A) until it releases from the seat, as
shown.
2. Unscrew front plate (B) from head, pull out the
plate, and disconnect the lamp wires from the
electrical board. Remove old lamp assembly.
3. Install new lamp assembly and push it firmly
into the seat. Connect the wires and reinstall
front plate.
Figure 28