Owner Manual Cut-Off Saw COS18

13
To mount roller tables to saw:
1. Mount an angle bracket to the pre-drilled
holes in the side of the saw cabinet with four
M8 x 20 hex cap screws and four M8 flat
washers (Fig. 10). Do not fully tighten yet.
2. Place the roller table upside down on a flat
surface and attach the leg assemblies with
four M8 x 25 hex cap screws, eight M8 flat
washers, and four M8 hex nuts per leg
assembly (Fig. 11).
3. Screw an adjustable foot pad into each leg
as shown in Figure 12.
4. Flip the roller table right-side up and mount it
to the angle bracket on the cabinet as shown
in Figure 10. Use two M8 x 25 screws, four
M8 flat washers and two M8 hex nuts. Do not
fully tighten yet.