PM15 Planer/Molder Planing or moldings, the choice is yours – with the new PM15 from Powermatic, you can do both with one machine. Loaded with features and built for performance and value. The Gold Standard Since 1921.
PM15 Planer/Molder The new PM15 from Powermatic is loaded with features that make it a standout. Large 5HP motor gives the unit 15" wide planing capacity and enough power to run double knife sets for molding. ■ The stand is fully enclosed and is equipped with integral casters for shop mobility. ■ Two feed speeds, 10 and 20 fpm’s allow you to run quickly for maximum stock removal yet slower speeds yield a fine milled finish on decorative moldings.
Large handwheel and easy to read inch/metric scale for fast set up Heavy duty cast iron table supported by 4 columns for accuracy 2-speed gearbox for rough and finish work Big 5HP motor accommodates 15" x 61/2" capacity Integral casters for complete mobility
Knives Moldings Cove Moldings 3/4" x 3/4" 4570930 • Designed for use in a corner as a smooth blend between two right angled surfaces, at floor or ceiling • Smaller sizes often used to clean up corners in paneling or to give a finished look beneath the overhang of a desktop Chair Rail Moldings 1. 4570297 11/16" x 3" 2.
Knives Moldings Brick Molding 4571800 up to 25/8" thick (brick molding) • Thick molding provides a surface for brick or other siding Base Cap Moldings 11/16" x 13/8" 4571630 • For use on the top edge of a standard flat baseboard to give it a more ornate look • Closes the gap between uneven walls and baseboards • Also for use as trim where brick or stucco meet wood on exterior walls Stop Moldings 1/2" x 13/8" 4579260 • In window frame applications, these moldings hold the sashes in place • On doors, the
PM15 Planer/Molder Model Number PM15 Stock Number 1120003 Motor HP/Voltage/Phase Working Width 5HP 230V 1PH 15" Maximum Depth Cut Planing 1/8" Maximum Depth Cut Molding 3/4" Minimum Thickness 3/16" Maximum Thickness Urethane Infeed Roller Diameter 61/2" 11/2" Urethane Outfeed Roller Diameter 11/2" Feed Speeds Table Size L x W 10/20 fpm 271/2" x 151/8" Minimum Length Workpiece 8" Table Height Adjust 1 Turn = 1/16" Scale/Cursor Cutter Diameter Inch/Metric 27/8" Cutter Diameter with Kni
