Table Saw Specification Sheet

Advanced Miter Gauge
The standard miter gauge
supplied with the
POWERMATIC PM2000
pivots 60-degrees to either
side and locks with a twist of
the push handle. However,
that is where the similarities
with other standard models
end.
The guide bar has a disk
follower that engages the T-groove miter slots and prevents it from lifting during a cut. A pair of
expander mechanisms allows fitting the guide bar precisely to the miter slot to eliminate side
play. This enhances both safety and precise cuts in crosscut and miter modes.
(Left) The large miter gauge fence is fully adjustable so it can be positioned
safely for whatever cut is being made. (Right) A built in gear drive makes
dialing in precise angles fast and easy.
The miter head has precisely located detents at 0, 30 and 45-degrees to the left and right. To
make setting any required angle more precise, a special gear drive is built into the detent knob.
Loosen the locking handle, pull the detent knob out to engage the gear drive and turn it to move
the miter head to the exact angle needed. It simply cannot be
easier or more accurate!
The large 12 ¾”-long by 2 ¾”-tall extruded fence can be
positioned closer to or farther from the blade by releasing the
two finger-operated levers. This allows setting the miter fence
at the optimum distance from the blade at all cutting angles for
maximum accuracy and safety.
The miter guide bar has a pair of
width adjusters to eliminate side play
that could compromise cut accuracy.
Slots in the face and top edge of the miter gauge fence accept hex head fasteners to make
attaching your custom auxiliary faces or shop-made jigs easy and very secure.