User Manual
Table Of Contents
- WP2510 Planer
- Warranty and Service
- Table of Contents
- Warnings
- WP-2510 floor diagram
- Specifications
- Unpacking
- Installation and Assembly
- Grounding Instructions
- Adjustments
- Test Cutting andTroubleshooting
- Operation
- Maintenance
- Controller (M15S) Operating Instructions
- 1. Front Panel Overview
- 2. Operation Modes
- 3. Fast Program (10 sets)
- 4. Select Counting direction
- 5. Select Positioning Mode
- 6. Set Software Limit (Hi/Lo End)
- 7. Set Tolerances
- 8. Set Low Speed Limit
- 9. Set Linear Correction
- 10. Enter Parameter Setttings Mode
- 11. Check Software Version
- 12. Load Datum Values
- 13. IN/MM Conversion
- 14. Set Device Resolution
- 15. Calibration
- 16. M15S Troubleshooting
- 17. M15S Specifications
- 18. M15S Parameters
- Troubleshooting
- Replacement Parts
- Electrical Connections
23
Example:
Assume:
target value on display = 100.00mm
real value on display = 100.00mm
To change the target value to 20.25mm,
Step 1: Press
, the LED lamp on Target window is blinking.
Display
Step 2: Enter new target value (example: 20.25mm)
Press
Display
Step 3: Press
to complete.
The
LED lamp is blinking – ready for positioning.
Press
to start the positioning or press
to cancel.