User Manual
Table Of Contents
- WP2510 Planer
- Warranty and Service
- Table of Contents
- Warnings
- WP-2510 floor diagram
- Specifications
- Unpacking
- Installation and Assembly
- Grounding Instructions
- Adjustments
- Test Cutting andTroubleshooting
- Operation
- Maintenance
- Controller (M15S) Operating Instructions
- 1. Front Panel Overview
- 2. Operation Modes
- 3. Fast Program (10 sets)
- 4. Select Counting direction
- 5. Select Positioning Mode
- 6. Set Software Limit (Hi/Lo End)
- 7. Set Tolerances
- 8. Set Low Speed Limit
- 9. Set Linear Correction
- 10. Enter Parameter Setttings Mode
- 11. Check Software Version
- 12. Load Datum Values
- 13. IN/MM Conversion
- 14. Set Device Resolution
- 15. Calibration
- 16. M15S Troubleshooting
- 17. M15S Specifications
- 18. M15S Parameters
- Troubleshooting
- Replacement Parts
- Electrical Connections
25
Step 5: Press ...............................................[select program key 1]
Step 6: Press
............................................[enter value]
Step 7: Press
..................................................................[complete]
Step 8: Press
to exit.
Execute:
Step 1: Enter single mode,
LED lamp is off.
Step 2: Press a key 0 to 9.
LED lamp is blinking, ready for start.
Example: Program 0 = 10.00mm; Program 1 = 20.00mm.
Step 1: In Single Mode,
LED lamp is off.
Step 2: Press
...................................................[Program 0]
Now you will see the preset value: 10.00mm (Program 0]
LED lamp is blinking, complete.
Press
to begin positioning.