User Manual
Table Of Contents
- WP2510 Planer
- Warranty and Service
- Table of Contents
- Warnings
- WP-2510 floor diagram
- Specifications
- Unpacking
- Installation and Assembly
- Grounding Instructions
- Adjustments
- Test Cutting andTroubleshooting
- Operation
- Maintenance
- Controller (M15S) Operating Instructions
- 1. Front Panel Overview
- 2. Operation Modes
- 3. Fast Program (10 sets)
- 4. Select Counting direction
- 5. Select Positioning Mode
- 6. Set Software Limit (Hi/Lo End)
- 7. Set Tolerances
- 8. Set Low Speed Limit
- 9. Set Linear Correction
- 10. Enter Parameter Setttings Mode
- 11. Check Software Version
- 12. Load Datum Values
- 13. IN/MM Conversion
- 14. Set Device Resolution
- 15. Calibration
- 16. M15S Troubleshooting
- 17. M15S Specifications
- 18. M15S Parameters
- Troubleshooting
- Replacement Parts
- Electrical Connections
28
8. Set Low Speed Limit
This function defines the speed level which is considered abnormal for the machine.
When the Controller starts the table movement up or down, and the table does not
move, or moves with a speed lower than defined, it stops the machine and displays:
Press
to clear.
To set low speed limit:
Step 1: Press
Display
..........................[default]
Step 2: Enter the low speed level 0 to 99
0 = Machine test is disabled
1 = very low
:
:
99 = high
Step 3: Press
to confirm or press
to clear.