User Manual
Table Of Contents
- WP2510 Planer
- Warranty and Service
- Table of Contents
- Warnings
- WP-2510 floor diagram
- Specifications
- Unpacking
- Installation and Assembly
- Grounding Instructions
- Adjustments
- Test Cutting andTroubleshooting
- Operation
- Maintenance
- Controller (M15S) Operating Instructions
- 1. Front Panel Overview
- 2. Operation Modes
- 3. Fast Program (10 sets)
- 4. Select Counting direction
- 5. Select Positioning Mode
- 6. Set Software Limit (Hi/Lo End)
- 7. Set Tolerances
- 8. Set Low Speed Limit
- 9. Set Linear Correction
- 10. Enter Parameter Setttings Mode
- 11. Check Software Version
- 12. Load Datum Values
- 13. IN/MM Conversion
- 14. Set Device Resolution
- 15. Calibration
- 16. M15S Troubleshooting
- 17. M15S Specifications
- 18. M15S Parameters
- Troubleshooting
- Replacement Parts
- Electrical Connections
30
11. Check Software Version
To check the released version of the M15S Controller program:
Step 1: Press
Display
In the real value window, you will see the released version.
Step 2: Press
to confirm or press
to clear.
12. Load Datum Values
The real value refers to the distance between the machine table and the cutterhead.
Thus, the cutterhead defines the zero point of the machine. It is, however, difficult or
impossible to move the planer table to this point. Therefore, the zero point should be
identified by either placing a gauge between table and cutterhead knife insert, or by
planing a test board then measuring the board thickness with calipers. Program this real
value into the Controller as follows.
Preset the real value:
Step 1:
Step 2: Enter the value.
Step 3: Press