User Manual
Table Of Contents
- WP2510 Planer
- Warranty and Service
- Table of Contents
- Warnings
- WP-2510 floor diagram
- Specifications
- Unpacking
- Installation and Assembly
- Grounding Instructions
- Adjustments
- Test Cutting andTroubleshooting
- Operation
- Maintenance
- Controller (M15S) Operating Instructions
- 1. Front Panel Overview
- 2. Operation Modes
- 3. Fast Program (10 sets)
- 4. Select Counting direction
- 5. Select Positioning Mode
- 6. Set Software Limit (Hi/Lo End)
- 7. Set Tolerances
- 8. Set Low Speed Limit
- 9. Set Linear Correction
- 10. Enter Parameter Setttings Mode
- 11. Check Software Version
- 12. Load Datum Values
- 13. IN/MM Conversion
- 14. Set Device Resolution
- 15. Calibration
- 16. M15S Troubleshooting
- 17. M15S Specifications
- 18. M15S Parameters
- Troubleshooting
- Replacement Parts
- Electrical Connections
32
13. IN/MM Conversion
The dedicated mm/inch key allows for immediate switch of the units between millimeters
and inches. The LEDs on the key indicate the selected unit. Switching between MM and
INCHES has no effect on the control functions.
14. Set Device Resolution
Step 1: Press
Step 2: Use
to select resolution.
Step 3: Press
to confirm or press
to clear.
15. Calibration
Step 1: Press
Display
Step 2: Use
to move the planer table until
M15S terminates the calibration and restarts.