User Manual
Table Of Contents
- WP2510 Planer
- Warranty and Service
- Table of Contents
- Warnings
- WP-2510 floor diagram
- Specifications
- Unpacking
- Installation and Assembly
- Grounding Instructions
- Adjustments
- Test Cutting andTroubleshooting
- Operation
- Maintenance
- Controller (M15S) Operating Instructions
- 1. Front Panel Overview
- 2. Operation Modes
- 3. Fast Program (10 sets)
- 4. Select Counting direction
- 5. Select Positioning Mode
- 6. Set Software Limit (Hi/Lo End)
- 7. Set Tolerances
- 8. Set Low Speed Limit
- 9. Set Linear Correction
- 10. Enter Parameter Setttings Mode
- 11. Check Software Version
- 12. Load Datum Values
- 13. IN/MM Conversion
- 14. Set Device Resolution
- 15. Calibration
- 16. M15S Troubleshooting
- 17. M15S Specifications
- 18. M15S Parameters
- Troubleshooting
- Replacement Parts
- Electrical Connections
33
16. M15S Troubleshooting
Display
“Change RST” message appears when the Controller detects a motion in the wrong
direction. For example, the Controller switches the outputs to move upward but the table
starts moving in reverse direction. Usually this is caused by incorrect wiring of the three
phase motor.
Press to clear.
Check the wiring and change if necessary.
Display
Possible cause:
a. no sensor
b. 9-pin connector is loose
c. wire broken
d. the gap between sensor and tape is too large
Excluding: Check the sensor, sensor cable, sensor connector, and adjust gap (if
necessary).
Display
Possible cause: Incorrect operation; check parameter setting.
Excluding: Press to clear.