User Manual
Table Of Contents
- WP2510 Planer
- Warranty and Service
- Table of Contents
- Warnings
- WP-2510 floor diagram
- Specifications
- Unpacking
- Installation and Assembly
- Grounding Instructions
- Adjustments
- Test Cutting andTroubleshooting
- Operation
- Maintenance
- Controller (M15S) Operating Instructions
- 1. Front Panel Overview
- 2. Operation Modes
- 3. Fast Program (10 sets)
- 4. Select Counting direction
- 5. Select Positioning Mode
- 6. Set Software Limit (Hi/Lo End)
- 7. Set Tolerances
- 8. Set Low Speed Limit
- 9. Set Linear Correction
- 10. Enter Parameter Setttings Mode
- 11. Check Software Version
- 12. Load Datum Values
- 13. IN/MM Conversion
- 14. Set Device Resolution
- 15. Calibration
- 16. M15S Troubleshooting
- 17. M15S Specifications
- 18. M15S Parameters
- Troubleshooting
- Replacement Parts
- Electrical Connections
34
Display
This message appears after power-on and indicates battery discharged. The C-type
battery MUST be replaced to resume the operation of the device. Change as follows:
1. Open the planer’s top right side panel to access the rear of the Controller.
2. Turn the power off. Be careful not to move the table during power off. Replace the
battery and turn the power on. The device will resume normal operation.
17. M15S Specifications