User Manual
Table Of Contents
- WP2510 Planer
- Warranty and Service
- Table of Contents
- Warnings
- WP-2510 floor diagram
- Specifications
- Unpacking
- Installation and Assembly
- Grounding Instructions
- Adjustments
- Test Cutting andTroubleshooting
- Operation
- Maintenance
- Controller (M15S) Operating Instructions
- 1. Front Panel Overview
- 2. Operation Modes
- 3. Fast Program (10 sets)
- 4. Select Counting direction
- 5. Select Positioning Mode
- 6. Set Software Limit (Hi/Lo End)
- 7. Set Tolerances
- 8. Set Low Speed Limit
- 9. Set Linear Correction
- 10. Enter Parameter Setttings Mode
- 11. Check Software Version
- 12. Load Datum Values
- 13. IN/MM Conversion
- 14. Set Device Resolution
- 15. Calibration
- 16. M15S Troubleshooting
- 17. M15S Specifications
- 18. M15S Parameters
- Troubleshooting
- Replacement Parts
- Electrical Connections
6
Introduction
This manual is provided by Powermatic, covering the safe operation and maintenance procedures for a
Powermatic Model WP2510 Planer. This manual contains instructions on installation, safety precautions,
general operating procedures, maintenance instructions and parts breakdown. This machine has been
designed and constructed to provide years of trouble free operation if used in accordance with
instructions set forth in this manual. If there are any questions or comments, please contact either your
local supplier or Powermatic. Powermatic can also be reached at our web site: www.powermatic.com.
WP-2510 floor diagram