PMTS Install Guide

AC POWER TRANSFER SWITCH
PMTS-30 and PMTS-50
Transfer Switch for 120 or 240Vac
30 and 50 Amps
SAFETY ALERT
FOR YOUR SAFETY, READ ALL INSTRUCTIONS BEFORE INSTALLATION AND OPERATION.
INSTALLER: Provide these instructions to the end user or consumer.
CONSUMER: Keep these instructions for future reference.
NOTICE: Products are not to be used nor are warranted in aerospace, medical or lifesafety
applications.
WARNING – Avoid Possible Injury or Death
120 or 240 VAC may present. Risk of electric shock: This device switches 120Vac or 240Vac and
has more than one input. All inputs must be disconnected before any work is done on this product.
WARNING – Avoid Personal Injury or Product Damage
DO NOT mount/install unit in compartments designed for storage of batteries of flammable liquids.
The PMTS-30 and PMTS-50 are not ignition protected. They employ components that tend to
produce arcs or sparks. To prevent fire or explosion, NEVER install electrical devices in
compartments where batteries or flammable materials (such as gasoline or LP gas) are stored or
used.
The PMTS-30 and PMTS-50 are for a 30 and 50 Amp AC service respectively. It can be mounted in any
position, leaving enough room for the shoreline and generator wire connections. To minimize voltage drop
across the wire, install the PMTS-30 or PMTS-50 as close to the generator and shore power cord
entrance as possible.