Full Product Manual

ManualsBrandsPOWERNAIL ManualsFloor Installation KitsPneumatic 18-Gauge Engineered Flooring Stapler Kit

CLEARING A JAM

Disassembly: (See pictures below)

1) Loosen the 4 M4 screws (35) with a 3mm allen wrench.

2) Slide the gate plate down until it is free from the nose..

3) Lift the gate plate (36) off.

4) Inspect and clear any debris from the drive blade (13A) and its path.

Reassembly:

1) Install the the gate plate (36) over the four M4 screws (35).

2) Slide the gate plate upwards as far as it go.

3) Tighten the four M4 screws (35).

4) Unit is ready for funtional testing.

Step 1: Loosen 4 screws.

Step 2. Slide gage plate off.

Step 3. Clear drive blade path and reassemble.

Figure 3

CONNECTING THE TOOL TO AN AIR SUPPLY

Your air tool is fully assembled when you

receive it. Before using it, attach the air line

and desired air system accessories. Be

sure the air hose is depressurized when

installing or removing adapters to the air line.

To prevent misﬁ re, do not connect air to a

loaded stapler.

Figure 2

AIR HOSE

1. An automatic airline oilier is recommended but

oil may be added manually before every operation

or after about 8 hours of continuous use.

2. Place two (2) drops of air-tool oil in the air plug

as shown (Figure 3). If you are using an automatic

in-line oiler, check and add oil if necessary.

3. Turn your compressor on and set the

compressors pressure regulator to the proper

pressure. Normal operating pressure should be

adjusted between 70-110 psi based on fastener

and wood being used.

4. Connect the tool to the air supply (Figure 2).

FOOT ADJUSTMENT / NAIL LOCATION

Flip the lever (1A) on the FLEX Foot to

one side so the FLEX Foot is free to slide

on the channel.

Using a sample of your ﬂ ooring, slide the

FLEX Foot back on the channel and set

the nose of the stapler (1B) on top of the

ﬂ ooring tongue.

Keeping the nose ﬂ ush on the ﬂ ooring

tongue, slide the FLEX Foot forward until

it lies ﬂ at on the ﬂ ooring surface (2A).

Flip the adjustment lever

and tighten it (2B) so the

FLEX Foot is locked in

place.

Always test ﬁ re into your

sample wood to ensure

the nail is setting correctly

(Figure 1).

Adjust the FLEX Foot to your wood...

Nailer

Quick

Connector

Figure 1.