Use and Care Manual
Figure 3
3
SETTING
Your air tool is fully assembled when you receive
it. Before using it, attach the air line and desired
air system accessories. Be sure the air hose is
depressurized when installing or removing adapters to
the air line. To prevent misre, do not connect air to a
loaded nailer.
OPERATING INSTRUCTIONS
Figure 2
STAPLER
QUICK
CONNECTOR
OILER
REGULATOR
AIR HOSE
AIR SUPPLY
CONNECTING THE TOOL TO AN AIR SUPPLY
1. Determine if the tool needs oil. An automatic airline oilier is
recommended but oil may be added manually before every
operation or after about 1 hour of continuous use.
2. Place two (2) drops of air-tool oil in the air plug as shown in
Figure 3. If you are using an automatic in-line oiler, check and
add oil if necessary.
3. Turn your compressor on and set the compressors pressure
regulator to the proper pressure for the size and type of fastener
being used. Normal operating pressure should be adjusted
between 60-100 psi based on fastener and wood being used.
4. Connect the tool to the air supply (gure 2).
FOOT ADJUSTMENT / STAPLE LOCATION
Figure 1.
Loosen both adjusting knobs (76)
Hold stapler on sample piece of sample
ooring to be installed.
Adjust the face pad (74) so it lays at on
the nished surface of the ooring (Fig 1).
Lightly snug both adjusting knobs (76).
Push down on front stand (73) so it lays
at on the sub oor.
Tighten both adjusting knobs (76).
Test the adjustment by stapling down a
sample piece of oor
Readjust if necessary so that the staple
insertion point enters the top of the ooring
nail pocket.