Use and Care Manual
1. Frequent, but not excessive, lubrication is required for
best performance. Oil added through the airline connection
will lubricate internal parts. An automatic airline oilier is
recommended but oil may be added manually before every
operation or after about 1 hour of continuous use.
Only a few drops of oil at a time are necessary. Too much
oil will collect inside the tool and be blown out during the
exhaust cycle. ONLY USE PNEUMATIC TOOL OIL. Do not
use detergent oil or additives, as these lubricants will cause
accelerated wear to the seal in the tool.
2. Use a small amount of oil on all moving surface and pivots.
5
REGULAR MAINTENANCE
Figure 3
3. Dirt and water in the air supply are major causes of pneumatic tool wear. Use a lter/
oiler for better performance and longer life. The lter must have adequate ow capacity for
the specic application. Consult the manufacturer’s instructions for proper maintenance of
your lter.
4. Keep tools clean for better and safer performance. Use nonammable cleaning
solutions (CAUTION: Such solutions may damage O-ring and other tool parts) only if
necessary- DO NOT SOAK.