Use and Care Manual

ADAPTER FOOT
LOCATING EAR
3
FLEX Foot Adjustment:
Wood varies from one manufacturer to the
next. The different wood proles may be due
to height and length of the ooring tongue
and whether or not there is a nail pocket.
First, loosen the two hex bolts under the
FLEX foot with the Allen Wrench supplied
with the nailer. (Figure 1.)
Next, set the nailer on a sample of your
ooring (see Figure 2).
Use the adjustment lever at the back of the
nailer foot to raise or lower the nailer to the
wood.
Match the Adapter Foot Locating Ear so that
it is pointing into the 90° angle created
by the tongue and the top of the wood (see
Figure 3).
For wood with a nail pocket, line up the
Locating Ear so at the top of the nail pocket.
When the adjustment lever is in the correct
position for your wood sample, tighten the
two hex bolts to lock the FLEX foot into
place.
Always check your adjustment with a sample
to ensure the nail is driving into the nail
pocket
Figure 2.
Hex Allen Wrench
FLEX Adjustment Lever
1. Loosen 2 hex screws.
2. Raise or lower the FLEX to your wood sample.
3. Match the Locating Ear to the nail pocket.
4. Tighten 2 hex screws.
5. Test wood sample with new adjustment.
Figure 1.
Figure 3.
Set the nailer on a sample of your ooring.
Raise the nailer foot above the tongue
to line up the nail pocket.