Use and Care Manual

ManualsBrandsPOWERNAIL ManualsClampsRatcheting Flooring Jack for Installing Hardwood and Engineered Floor Boards

Read this manual before you use this Powerjack. Follow all safety warnings and instructions. If you

are uncertain about the operation of the Powerjack, call us directly at 1-800-323-1653 for assistance or

contact the closest Powernail Dealer for help. Please retain this information for future reference.

WARNING

REV 7.08

Operation and Maintenance Manual

MODEL 100 Powerjack Manual

POWERNAIL

CO.

1300 Rose Road, Lake Zurich, IL 60047

Phone: 1-800-323-1653

Website: www.powernail.com

™

Use the Model 100 Powerjack to pull together and hold

hardwood ooring in place while nailing.

Summary of content (4 pages)

PAGE 1
POWERNAIL® CO. 1300 Rose Road, Lake Zurich, IL 60047 Phone: 1-800-323-1653 Website: www.powernail.com Operation and Maintenance Manual MODEL 100 Powerjack™ Manual Use the Model 100 Powerjack to pull together and hold hardwood flooring in place while nailing. WARNING Read this manual before you use this Powerjack. Follow all safety warnings and instructions.
PAGE 2
Model 100 Powerjack The POWERJACK Model 100 is designed to pull flooring strips into place and hold them tightly for hands-free nailing. Easy to operate! Use the lever handle to ratchet the faceplate against a stationary surface. Continue to ratchet until the floor catch draws the flooring to the desired position. The POWERJACK can be left in place while you nail down the flooring strip. To release the POWERJACK, simply push the handle to full forward position.
PAGE 3
Picture 1 The Model 100 pushes against a stud location on a stationary wall to pull the strips into place. Great for snugging-up end strips against walls, wall trim or fixed cupboards or cabinets (see picture 1). Picture 2 When a stud location cannot be determined, a board long enough to span the distance of the studs should be used to prevent breaking through the drywall (see picture 2).
PAGE 4
Model 100 Powerjack Safety Always use approved eye protection. Keep fingers away from gear area. Do not hit the ratchet handle with a mallet. Do not over torque. Model 100 Powerjack Exploded View PART NAME PART NO. 1. KNOB 08-100-00-010 2. HANDLE 08-100-00-020 3. RATCHET SHAFT 08-100-00-030 4. RATCHET SPRING 08-100-00-040 5. GEAR SHAFT 08-100-00-050 6. GEAR 08-100-00-060 7. GEAR SHAFT NUT 08-100-00-070 8. COTTER PIN 08-100-00-080 9. PAWL BUSHING 08-100-00-090 10.