Use and Care Manual

DETERGENT INJECTOR
Using water only can complete some cleaning jobs, but for most job requirements,
a detergent is recommended in order to penetrate and remove the dirt more effectively.
When using a pressure washer approved detergent, make sure the surface is dry.
Wetting the surface first is not recommended. It will dilute the detergent and will reduce the
cleaning effectiveness.
Avoid hot surfaces or direct sunlight. This will minimize the chances of the detergent damaging
the painted surface.
DO NOT let the detergent dry out or it may damage the painted surface. Allow the
detergent to remain on the surface for a short time before rinsing with clean water
under high pressure.
• This pressure washer is intended for use with qualified branded pressure detergents only.
• Do not use powdered soaps, which can clog the injection system.
• Follow the detergent manufacturer’s directions.
• The siphon tubes come pre-assembled in the soap tank cap from POWERPLAY™.
• Soap tanks will hold your liquid soap and work automatically with the low pressure
black spray tip.
• When using a detergent, the wand must be fitted with the black tip detergent nozzle.
• If the throttle lever is not in the fast position, the injection of the detergent may be decreased or
stopped completely. In this case move, the throttle lever to full / wide open position, to increase
engine speed and pressure.
• When finished using the detergent, replace the low pressure black spray tip with a
high-pressure tip, (white, green, red, or yellow).
Suggested Duty Cycle
A Duty Cycle is the time the pressure washer is in an active state.
Suggested Duty Cycle;
50 seconds on (trigger pulled, under pressure)
20 seconds off (trigger released, pump unloaded)
6 - English