Operation Manual

POW30060 EN

5.4 Power tool use and care

! Do not force the power tool. Use the correct power tool for your application. The correct

power tool will do the job better and safer at the rate for which it was designed.

! Do not use the power tool if the switch does not turn it on and off. Any power tool that

cannot be controlled with the switch is dangerous and must be repaired.

! Disconnect the plug from the power source before making any adjustments, changing

accessories, or storing power tools. Such preventive safety measures reduce the risk of

starting the power tool accidentally.

! Store idle power tools out of the reach of children and do not allow persons unfamiliar with

the power tool or these instructions to operate the power tool. Power tools are dangerous in

the hands of untrained users.

! Maintain power tools. Check for misalignment or sticking of moving parts, breakage of parts

and any other condition that may affect the power tool’s operation. If damaged, have the

power tool repaired before use. Many accidents are caused by poorly maintained power

tools.

! Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting

edges are less likely to stick and are easier to control.

! Use the power tool, accessories and tool bits etc., in accordance with these instructions and

in the manner intended for the particular type of power tool, taking into account the working

conditions and the work to be performed. Use of the power tool for operations different from

intended could lead to a hazardous situation.

5.5 Service

! Have your power tool serviced by a qualified repair person using only identical replacement

parts. This will ensure that the safety of the power tool is maintained.

6 ASSEMBLY

6.1 Inserting and removing a drill or screw bit (fig. A)

! Open the chuck (7).

! Insert the drill or the screw bit in the chuck.

! Tighten the chuck firmly.

! In order to remove a drill or screw bit, proceed in reverse order.

Before inserting or removing a drill or screw bit always pull the plug from

the wall socket.

6.2 Mounting the side grip (fig. A)

! Loosen the side grip (6).

! Slide the holder of the side grip over the drill chuck on the machine.

! Turn the side grip in the required position and tighten it firmly.

6.3 Mounting the depth stop (fig. A)

The depth stop is used to limited the maximum drilling depth.

! Loosen the side grip (6).

! Insert the depth stop (8) in the hole in the holder of the side grip.

! Adjust the depth stop to the required drilling depth.

! Tighten the side grip firmly.