Operation Manual

POW30060 EN

7 OPERATION

7.1 Selecting the operating mode (fig. A)

Select the required operating mode before use (drilling or hammer drilling).

! For drilling in wood

metal, plastics and soft stone and for driving screws, slide the switch (5)

to the left.

! For drilling in concrete or hard stone, slide the switch (5) to the right.

Always wait until the motor has come to a complete standstill before

changing the operating mode.

7.2 Changing the direction of rotation (fig. A)

! Press the forward/reverse switch (4) to the left to drill or to fasten screws.

! Press the forward/reverse switch (4) to the right to loosen screws,

Always wait until the motor has come to a complete standstill before

changing the direction of rotation.

7.3 Adjusting the speed (fig. A)

This machine has been fitted with an adjusting wheel (2) for the maximum speed.

! Turn the adjusting wheel (2) as indicated on switch (1) to set the maximum speed.

7.4 Switching on and off (fig. A)

! To switch the machine on, press the on/off switch (1). The further you press the switch, the

higher the speed of the machine.

! To switch off the machine, release the on/off switch (1).

! To switch the machine to continuous mode, keep the on/off switch (1) pressed and at the

same time press the lock-on button (3). Subsequently release the on/off switch.

! To switch off continuous mode, press the on/off switch (1) again.

8 TECHNICAL DATA

Mains voltage 230V

Mains frequency 50Hz

Power input 800W

No load speed 0-2.800 min

-1

N° of strokes no load 0-42.000 min

-1

Chuck capacity 13mm

Weight 2.4Kg

9 SOUND EMISSION

Level of sound pressure measured according to ISO 3744:

LpA (sound pressure) dB(A) 92

LpW(sound power) dB(A) 103

Weighted mean square acceleration <5.7m/s

Take appropriate measures for the protection of hearing.