Operation Manual

POW8562 EN
Copyright © 2016 VARO P a g e | 11 www.varo.com
 Remove the screws (29 of the table insert.
 Remove the table insert
 Use the crank and turn to the left to bring the saw blade as far up as it will go.
 Use the wrenches (16-17) to remove the screw on the saw blade (Fig. 9) and exchange
the blade with a suitable replacement. Watch the direction of operation! See the arrow on
the saw blade. The teeth must point towards the on/off switch (1).
9.3.2 Adjusting the cleaving wedge (Fig. 10)
The gap between the external edge of the saw blade and the cleaving wedge (9) must be
between three and five millimetres.
 Bring saw blade angle to the 0° position and tighten.
 Bring the saw blade into the upper position.
 Remove the saw blade protector.
 Remove the table surface.
 Loosen the screws (A) slightly with a suitable combination wrench until the cleaving wedge
(9) is released (do not remove screws)
 Set the cleaving wedge lower or higher by pushing upward or downward in the long hole.
 Mount all dismantled parts in reverse sequence.
10 STORAGE, TRANSPORTATION
10.1 Storage
Risk of injury! Store the unit in such a way that it cannot be started by
unauthorised persons. Ensure that no one is able to injury themselves on
the stored unit.
Machine damage! Do not store unprotected in a damp environment.
10.2 Transportation
Note: Only lift the unit using the handles.
 Crank the saw blade down as far as it will go.
 Parts that extend beyond the saw should be removed.
 Transport the unit with the assistance of another person and use the handles.
 When dispatching, try to use the original packaging, if possible.
11 TECHNICAL DATA
Rated Voltage
220-240 V
Rated Frequency
50 Hz
Rated Power
S6 25% 2000W
Weight
26 kg
Protection class
I
Degree of protection
IP20
Rotation speed
4800 min-1
Diameter of saw blade (external)
254 mm
Saw blade hole (internal)
30 mm
Saw blade thickness
2.8 mm
Number of teeth
60T