Operation Manual

POW8562 EN
Copyright © 2016 VARO P a g e | 7 www.varo.com
 Insert the stop plate (A) into the gaps of the angle adjustment (B) with both adjusting
screws (C), push into the required position and tighten the adjusting screws.
Push the gliding bar (D) of the mitre angle stop into the required bar of the table surface.
Note: Whether you insert the stop plate (A) with the long side upwards or
downwards is determined by the height of the workpiece.
Right-handed operators prefer to push the mitre angle stop into the left bar
of the table surface.
7.5 Mounting the saw blade guard (Fig. 5)
Risk of injury! The saw blade must be lowered as far as possible in order to
avoid injury.
 Push the bolt (26) onto the saw blade protection (8) and hold firm.
 Position the saw blade protection on the splitting wedge (9) so that bolt (26) engages in
the groove. Then release the bolt.
7.6 Mounting the extraction (Fig. 6)
 Screw the suction nozzle (27) to the housing using 4 Philips head screws M4×10 (28).
 Place the vacuum hose (6) on the connecting piece of the saw blade guard (8).
 Put the vacuum hose (6) on the vacuum connecting piece (27) on the rear of the device
8 OPERATION
Risk of injury! In the event of a functional fault, immediately press the red
button 0 on the On / Off switch and unplug.
8.1 Check before starting the device!
Risk of injury! The device may only be put into operation if there are no
defects. If a part is defective danger it must be replaced before the device is
used again.
Check to make sure the device is in safe operating condition:
 Check to make sure there are no visible defects.
 Check to make sure all device components are correctly mounted.
 Check to make sure the safety equipment is functioning properly.
 Check to make sure that the saw blade runs freely.
 Check whether the adjusting screw for setting the angle of tilt is tightened.
8.2 Operating elements
8.2.1 On/off switch
 Switching on: Pressing the green button I on the On / Off switch (1) switches on the saw.
Before starting to saw, wait until the blade has reached maximum speed.
 Switching off: Pressing the red button 0 on the On / Off switch (1) switches off the saw.