Operation Manual

POWX033 EN
Copyright © 2015 VARO NV P a g e | 6 www.varo.com
7.5 Dust extraction
The jigsaw is equipped with a dust extractor socket. Any vacuum cleaner can be connected to
the socket at the rear of the jigsaw. If you require a special adapter, please contact the
manufacturer of your vacuum cleaner.
7.6 Use of pendulum
See fig. 5
Position
Cutting action
Applications
0
Straight line cutting action
For cutting mild steel, stainless steel and plastics.
For clean cuts in wood and plywood.
I
Small orbit cutting action
For cutting mild steel, aluminum and hard wood.
II
Medium orbit cutting
action
For cutting wood and plywood.
For fast cutting in aluminum and mild steel.
III
Large orbit cutting action
For fast cutting in wood and plywood.
8 CLEANING AND MAINTENANCE
Attention! Before performing any work on the equipment, pull the power
plug.
8.1 Cleaning
 Keep the ventilation slots of the machine clean to prevent overheating of the engine.
 Regularly clean the machine housing with a soft cloth, preferably after each use.
 Keep the ventilation slots free from dust and dirt.
 If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
9 TECHNICAL DATA
Nominal voltage:
230-240V~50Hz
Power consumption:
600 W
Cutting rate:
800-3000 min-1
Stroke height:
18 mm
Cutting depth in wood:
65 mm
Cutting depth in plastic:
20mm
Cutting depth in iron:
8 mm
Mitre cuts:
up to 45° (left and right)
Double isolation
yes
Weight
2.1 Kg