Operation Manual

POWXQ5302 EN
Copyright © 2015 VARO P a g i n a | 8 www.varo.com
To adjust the cutting action, move the orbital switch knob between the four cutting position:
Position
Cutting action
Application areas
0
Straight line cutting action
For cutting soft steel and plastic
For clean cuts in wood and plywood
I
Small orbit cutting action
For cutting aluminium and solid wood
II
Medium orbit cutting action
For cuts in wood and plywood
III
Large orbit cutting action
For speedy cutting of wood and plywood
8.7 Replacing battery (fig 5)
Warning! Always ensure that the tool is switched off and the plug is
removed from the power point before making any adjustments or
maintenance procedures.
 Loosen the transparent (7) guard with hand.
 Move it downwards and pull it inclined away from the tool.
 Loosen the battery compartment with a screw driver.
 Remove first the steel section of the guard
 By unscrewing 2 screws, the battery compartment can be taken out.
 Replace the old batteries with new ones and make sure new batteries are installed in
correct positions.
 Put back the battery compartment and attach the blade guard properly.
8.8 Dust blowing switch (11)
This jig saw has a dust blowing switch (11) to control its dust blowing function. When you turn
the switch to the right position you enable the dust blow function. When you turn the switch to
the left you disable the dust blow function.
9 CLEANING AND MAINTENANCE
Attention! Before performing any work on the equipment, pull the power
plug (1).
9.1 Cleaning
 Keep the ventilation slots of the machine clean to prevent overheating of the engine.
 Regularly clean the machine housing with a soft cloth, preferably after each use.
 Keep the ventilation slots free from dust and dirt.
 If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
9.2 Service department
If the connecting cable (or mains plug) is damaged, it must be replaced. Replacement of the
connecting cable should only be carried out by a qualified specialist (qualified electrician).
10 TECHNICAL DATA
Rated Voltage
230V-240V
Rated frequency
50Hz
Rated input
900W