Technical data

POW0348 EN
Copyright © 2011 VARO P a g e | 6 www.varo.com
 Check whether the dust filter has been removed when using the machine far vacuuming
up liquids.
 If you use an extension cord, it must be of a watertight construction.
7 ASSEMBLY
7.1 Mounting the swivel castors (fig. B & C)
 Remove the motor housing (3).
 Turn the tub (7) upside down and insert the swivel castors (9) in the openings creating an
imaginary square while placing them.
 Turn the tub upright again.
 Re-fit the motor housing.
7.2 Mounting the hose (fig. A)
 Insert the hose (10) in the connection (8) and press it on firmly.
7.3 Fitting the dust filter (fig. B & E)
A dust back is suitable for collecting small waste material and dust.
 Remove the motor housing (3).
 Place a dust filter (18) over the float (19) completely.
 Re-fit the motor housing.
7.4 Fitting a dust bag (fig. B & E)
A dust bag is suitable for collecting small waste material and dust.
 Remove the motor housing (3).
 Place a dust bag (20) on the connection (21). Make sure to slide the opening past the
raised edge (22).
 Re-fit the motor housing.
7.5 Fitting and removing the motor housing (fig. A &B)
The motor housing has been locked to the tub with clamps.
 To remove the motor housing (3). first remove the clamps (6) and then lift it from the tub
(7).
 To re-fit the motor housing, place it on the tub and tighten the damps. While fitting the
motor housing make sure that the rubber sealing ring (17) fits to the tub correctly.
7.6 Mounting the tube to the hose (fig. A & F)
 Slide the tube on the handgrip (11).
 Place the required nozzle on the tail end of the tube.
7.7 Connecting an electrical tool (fig. A)
The machine has been equipped with an electronic outlet for connection of your electrical
equipment. The machine is switched on automatically the moment you switch on the electrical
tool.
 Connect the hose (10) directly to the dust extraction outlet of the electrical tool.
 Insert the mains plug of the electrical tool into the outlet (2).
8 OPERATION
Make sure the power cord has been fully unwound before you switch on the machine. The air
leaving the grids must not be hindered.
When using the machine in combination with an electrical tool, switch on the machine first and
then the electrical tool.
If the electrical tool has been connected to the electronic outlet, directly switch on the electrical
equipment.
Use the universal nozzle for vacuuming up dust from large surfaces. To keep delicate
materials free from scratches, insert the brush edge into the nozzle.