Technical data

POW0348 EN
Copyright © 2011 VARO P a g e | 7 www.varo.com
Use the crevice nozzle for vacuuming up dust from narrow and confined spaces.
Use the upholstery nozzle for vacuuming up dust from furniture.
When vacuuming up liquids, make sure the nozzle is not fully submerged in the liquid to be
vacuumed up.
Clean the machine after use according to instructions and wind the power cord around the
shell.
8.1 Switching on and off (fig. A)
 To switch on the machine for use without an electrical tool, set the on/off switch (1) to “I”.
 To switch on the machine for use with an electrical tool, set the on/off switch (1) to 'II'.
 To switch the machine off, set the on/off switch (1) to “O”.
8.2 Vacuuming up coarse waste material (fig. A & D)
 Check whether the dust filter (18) has been fitted,
 Mount the tube (12) to the hose (10).
8.3 Vacuuming up small waste material and dust (fig. A, D & E)
 Check whether the dust filter (18) has been fitted.
 Fit a dust bag (20).
 Mount the tube (12) to the hose (10).
8.4 Vacuuming up dust released from an electrical tool (fig. A, D & E)
 Check whether the dust filter (18) has been fitted.
 Fit a dust bag (20)
 Connect me hose (10) directly to the dust extraction outlet of the electrical tool.
8.5 Vacuuming up liquids (fig. A & D)
 Check whether the dust filter (18) has been removed.
 Make sure the inside of the tub (7) is clean and free from dust.
 Mount the tube (12) to the hose (10).
8.6 Emptying the tub (fig. A)
 Switch off and unplug the machine.
 Remove the motor housing (3).
 Empty the tub (7).
9 CLEANING AND MAINTENANCE
Attention !Before performing any work on the equipment, pull the power
plug.
9.1 Cleaning
 Keep the ventilation slots of the machine clean to prevent overheating of the engine.
 Regularly clean the machine housing with a soft cloth, preferably after each use.
 Keep the ventilation slots free from dust and dirt.
 If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
Do not submerge the motor housing in water!
9.2 Cleaning the tub (fig. A)
 Empty and clean the tub (7) after each use.