Operation Manual

POW4014 EN
Copyright © 2013 VARO P a g e | 5 www.varo.com
 Take special care when sanding lead based paint:
 All persons entering the work area must wear a mask specially designed for protection
against lead paint dust and fumes.
 Children and pregnant women must not enter the work area.
 Do not eat, drink or smoke in the work area.
 Do not leave the tool running. Operate the tool only when hand-held.
 Ventilate your work area adequately when you perform sanding operations.
 Be sure that there are no cracks or breakage on the pad before use. Cracks or breakage
may cause a personal injury.
7 OPERATION
Do not sand plaster surfaces, (WARNING: In this case your guarantee
becomes void) this may clog the motor (brushes, ball bearings, ..).
7.1 Switching on/off
 To switch on the machine press the on/off
switch.
 To switch off the machine, release the on/off
switch.
 To switch the machine to continuous mode, you
keep the on/off switch fully pressed and
simultaneously press the loch button. And
subsequently release the on/off switch.
 To switch off continuous mode, press the on/off
switch again.
7.2 Attaching the sandpaper
 Open the paper clamps.
 Take sanding paper of the required grain size
and place it on the sanding pad.
 Make sure that the perforation in the paper
corresponds with those on the sanding pad.
 Fold tha sanding paper at both ends around the
edges of the sanding pad.
 Close the paper clamps one by one.
 Make sure that the ends of the sanding paper
are clamped.
 The sanding paper must be fitted firmly on the
sanding pad and should not come loose.