Operation Manual

POW6129 EN
Copyright © 2015 VARO P a g e | 11 www.varo.com
10 CLEANING
 Use a damp cloth to clean the plastic parts.
 Do not use any detergents, solvents or pointed objects.
11 STORAGE
So that the hedge trimmer will work again after a long period of inactivity, you should
observe the following points:
 Empty the petrol tank. To do this, start the engine and let it run until it reaches a standstill.
Dispose of the remaining petrol in an environmentally friendly way.
 Let the engine cool and take out the spark plug.
 Pour a small spoonful of 2-stroke mixture into the spark plug opening and slowly pull the
starter cord right through to the end several times. This gets rid of small deposits of rust
and lubricates the piston and cylinder.
 Check the spark plug and replace it if too much of the firing tip has been burnt off.
 Keep the blade in a dry place – out of the reach of fire.
12 STARTING UP AFTER LONGER PERIODS OF INACTIVITY
 Remove the spark plug.
 Quickly pull the starter cord right through several times in order to remove oil and deposits
in the engine compartment.
 Check the spark plug, replace it if necessary and screw it in.
 Fill the petrol tank with the 2-stroke mixture.
13 TECHNICAL DATA
Engine displacement
22,5cc
Construction
Hand-held
Weight
5,65 kg
Fuel tank capacity
580ml
Blade length
600mm
Blade speed
2400 r/min
Max. engine speed
10000 r/min
Engine idle speed
3000 r/min
Clutch engagement speed
4000 r/min
Output power
650W
Engine oil / gasoline mixed ratio
1:40
14 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
88 dB(A)
Acoustic power level LwA
110 dB(A)
ATTENTION! Wear hearing protection when sound pressure is over 85 dB(A).
aw (Vibration):
Max 8.3 m/s²
K = 1.5 m/s²