User Manual

ManualsBrandsPowerplus ManualsGardening equipmentPOW63753 LAWNMOWER 118CC 400MM EN

POW637.. EN

Before reassembling the blade and the blade adapter to the unit, lubricate the engine

crankshaft and the inner surface of the blade adapter with light oil. Install the blade adapter on

the crankshaft with the "star" away from the engine. Refer to figure 9. Place the blade with the

part number facing away from the adapter. Align the washer over the blade and insert the hex

bolt. Tighten the hex bolt to the torque listed below:

9.3 Blade mounting torque

Center Bolt 40Nm.min, 54Nm.max. To insure safe operation of your unit. ALL nuts and bolts

must be checked periodically for correct tightness.

After prolonged use, especially in sandy soil conditions, the blade will become worn and lose

some of the original shape. Cutting efficiently will be reduced and the blade should be

replaced. Replace with an approved factory replacement blade only. Possible damage

resulting from blade unbalance condition is not the responsibility of the manufacturer.

When you change the blade, you must use the original type marked on the blade (for order the

balde, pls. contact your local dealer or call our company, see cover page)

Warning: Do not touch rotating blade.

9.4 Engine

Refer to the separate engine manual for engine maintenance instructions. Maintain engine oil

as instructed in the separate engine manual packed with your unit. Read and follow

instructions carefully.

Service air cleaner as per separate engine manual under normal conditions. Clean every few

hours under extremely dusty conditions. Poor engine perform ance and flooding usually

indicates that the air cleaner should be serviced.

To service the air cleaner, refer to the separate engine manual packed with your unit.

The spark plug should be cleaned and the gap reset once a season. Spark plug replacement

is recommended at the start of each mowing season; check engine manual for correct plug

type and gap specifications.

Clean the engine regularly with a cloth or brush. Keep the cooling system (blower housing

area) clean to permit proper air circulation which is essential to engine performance and life.

Be certain to remove all grass, dirt and combustible debris from muffler area.

Net Weight

(with grass

collector)

25Kg 28Kg 28Kg 28.5Kg 31.5Kg 31.5Kg

22.5Kg

Height

adjstment :

Level

25 mm

25 mm 25

30.5mm

36.25

36.1mm

47.5m

41.7mm

58.75

47.2mm

47.2mm 70mm

52.8mm

52.8mm /

58.3mm

58.3mm /

63.9mm

63.9mm /

69.5mm

69.5mm /

75mm

75mm /

Level