User Manual

ManualsBrandsPowerplus ManualsGardening equipmentPOW63753 LAWNMOWER 118CC 400MM EN

1 INTRODUCTION ............................................................................. 3

2 SAFETY MESSAGES ..................................................................... 3

3 SAFETY INFORMATION ................................................................ 3

4 COMPONENT & CONTROL LOCATION ....................................... 3

5 PRE OPERATION CHECKS ........................................................... 4

6 OPERATION.................................................................................... 4

6.1 Safe operating precautions ..................................................................................... 4

6.2 Starting the engine .................................................................................................. 4

6.3 Stopping the engine ................................................................................................ 6

7 SPECIFICATIONS ........................................................................... 6

8 TUNE-UP SPECIFICATIONS.......................................................... 6

9 SERVICING YOUR ENGINE ........................................................... 6

9.1 The importance of maintenance ............................................................................. 6

9.2 Maintenance safety ................................................................................................. 7

9.3 Safety precautions .................................................................................................. 7

9.4 Maintenance schedule ............................................................................................ 7

9.5 Refuelling ................................................................................................................. 8

9.5.1 Adding Fuel ............................................................................................................... 8

9.6 Engine oil ................................................................................................................. 9

9.6.1 Recommended Oil .................................................................................................... 9

9.6.2 Oil Level Check ......................................................................................................... 9

9.6.3 Oil Change .............................................................................................................. 10

9.7 Air cleaner ............................................................................................................. 10

9.7.1 Inspection ............................................................................................................... 11

9.7.2 Cleaning.................................................................................................................. 11

9.8 Spark plug ............................................................................................................. 11

9.9 Flywheel brake inspection (a types only) ............................................................. 12

10 ENGINE ADJUSTMENTS ............................................................. 13

11 HELPFUL TIPS & SUGGESTIONS .............................................. 13

11.1 Storing your engine ............................................................................................... 13

Summary of content (17 pages)

PAGE 1
EN 1 INTRODUCTION ............................................................................. 3 2 SAFETY MESSAGES ..................................................................... 3 3 SAFETY INFORMATION ................................................................ 3 4 COMPONENT & CONTROL LOCATION ....................................... 3 5 PRE OPERATION CHECKS ........................................................... 4 6 OPERATION........................................................
PAGE 2
EN 11.1.1 Storage Preparation ........................................................................................... 13 11.1.2 Cleaning ............................................................................................................. 13 11.1.3 Fuel .................................................................................................................... 14 11.1.4 Adding a gasoline stabilizer to extend fuel storage life........................................ 14 11.1.
PAGE 3
EN ENGINE DYM 1 P60FA, DYM 1 P64FA, DG600 1 § § § 2 INTRODUCTION Thank you for purchasing our engine. We want to help you to get the best results from your new engine and operate it safely. This manual contains information on how to do that; please read it carefully before operating the engine. This manual should be considered as a permanent part of the engine and should remain with the engine if resold.
PAGE 4
EN 5 PRE OPERATION CHECKS For your safety, and to maximize the service life of your equipment, it is very important to take a few moments to check the engine condition before operating Be sure to take care of any problem you find, or have your servicing dealer to correct it, before you operate the engine. WARNING Improper maintenance to this engine, or failure to correct a problem before operation, can cause a malfunction in which you can be seriously hurt or killed.
PAGE 5
EN A : Fuel valve lever A : cable hole A2. FOR RESTARTING A WARM ENGINE: § Do not use the choke when the engine is warm. § Move the throttle control slightly past the RUN position. B1. FLYWHEEL BRAKE MODELS: § Move the starter control handle (located on equipment) to release the flywheel brake. NOTICE Engine will stop if you release the starter control handle. Do not allow the starter grip to snap back against the engine. Return it gently to prevent damage to the starter 1. starter grip handle B2.
PAGE 6
EN 6.3 1. 2. 3. 4. Stopping the engine Turn the fuel valve to the OFF position FLYWHEEL BRAKE MODELS : Release the starter control handle (located on equipment) to stop the engine. Turn the control lever to the STOP position(located on equipment 1. brake cable 7 SPECIFICATIONS Type Dry weight(kg) Engine type Displacement[Bore x Stroke] Max.
PAGE 7
EN Other service tasks that are more difficult, or require special tools, are best handled by professionals and are normally performed by our technician or other qualified mechanics. The maintenance schedule applies to normal operating conditions. If you operate your engine under severe conditions, such as sustained high-load or high-temperature operation, or use in unusual wet or dusty conditions, consult your servicing dealer for recommendations applicable to your individual needs and use. 9.
PAGE 8
EN Flywheel brake pad Check X Spark arrester Replace Clean X Fuel tank and filter Clean X(3) Fuel tube Check Valve clearance Check/ adjust Combustion chamber Clean X Every 2 years(Replace if necessary (3) X(3) After every 200 hours (3) (1) Service more frequently when used in dusty areas. (2) Change engine oil every 25 hours when used under heavy load or in high ambient temperatures.
PAGE 9
EN Fuel tank capacity: 1.5L (0.47 US gallon) 2. Fuel cap 9.6 Engine oil 9.6.1 Recommended Oil Use 4-stroke motor oil that meets or exceeds the requirements for API service classification SH, SJ, or equivalent. Always check the API service label on the oil container to be sure it includes the letters SH, SJ, or equivalent. SAE 10W-30 is recommended for general use. Other viscosities shown in the chart may be used when the average temperature in your area is within the indicated range. 9.6.2 1.
PAGE 10
EN 4. If the oil level is near or below the lower limit mark on the dipstick, remove the oil filler cap/dipstick, and fill with the recommended oil to the upper limit mark (bottom edge of .the oil fill hole). Do not overfill. 5. Reinstall the oil filler cap/dipstick. NOTICE This engine is delivered without oil, be sure to put oil in the engine before the starting. Use a clean, detergent and high quality oil SAE30 and API.SG. SH OR SJ classification 9.6.
PAGE 11
EN Operating the engine without an air cleaner, or with a damaged air cleaner, will allow dirt to enter the engine, causing rapid engine wear. This type of damage is not covered under the warranty 9.7.1 Inspection A : Air cleaner case B : sealing washer C : air cleaner cover D : foam element 1. 2. 3. Remove the air cleaner cover. Be careful to prevent dirt and debris from falling into the air cleaner base. .Remove the air cleaner from the air cleaner base. .Inspect the air cleaner elements.
PAGE 12
EN 4. Measure the electrode gap with a suitable gauge. The correct gap is 0.028 - 0.031 in (0.70 0.80 mm). If adjustment is needed, correct the gap by carefully bending the side electrode. C : Sealing washer D : Electrode distance: 0.028~0.031 inch (0.70~0.80 mm Install the spark plug carefully, by hand, to avoid cross-threading. After the spark plug is seated, tighten with the proper size spark plug wrench to compress the washer.
PAGE 13
EN A : Fuel tank B : Flywheel C : Brake system 10 ENGINE ADJUSTMENTS NOTICE Do not change in any way the rated speed of the engine (carburator side or regulator side) Your engine was adjusted in the factory and the non-respect of the homologation speed engine could be dangerous for your safety and others safety. If the rated speed is changed in any way, the factory warranty will be cancelled. 11 HELPFUL TIPS & SUGGESTIONS 11.1 11.1.
PAGE 14
EN 11.1.3 Fuel Gasoline will oxidize and deteriorate in storage. Deteriorated gasoline will cause hard starting, and it leaves gum deposits that clog the fuel system. If the gasoline in your engine deteriorates during storage, you may need to have the carburettor, and other fuel system components, serviced or replaced.
PAGE 15
EN C : carburettor D : washer E : bolt 11.1.6 1. 2. 3. 4. 5. “OIL” : OIL B : Spark plug hole Engine Oil Change the engine oil. Remove the spark plug Pour a tablespoon (5 - 10 cc) of clean engine oil into the cylinder. Pull the recoil starter several times to distribute the oil. Reinstall the spark plug. 11.1.7 Clean fuel strainer A : Fuel strainer 11.1.
PAGE 16
EN Keep the engine level in storage. Tilting can cause fuel or oil leakage. With the engine and exhaust system cool, cover the engine to keep out dust. A hot engine and exhaust system can ignite or melt some materials. Do not use sheet plastic as a dust cover. A nonporous cover will trap moisture around the engine, promoting rust and corrosion. 11.2 Removal from storage Check your engine as described in the BEFORE OPERATION CHECKS section of this manual.
PAGE 17
EN 2. Check fuel Bad fuel; engine stored without treating or draining gasoline, of refuelled with bad gasoline Drain the fuel tan k and carburettor. Refuel with fresh gasoline 3. Take engine to an authorized our Servicing dealer, or refer to shop manual Fuel filter clogged, carburettor malfunction, ignition malfunction, valves stuck, etc Replace or repair faulty components as necessary. 13 13.