Operation Manual

ManualsBrandsPowerplus ManualsToolsPOW67915

POW67915 EN

1 APPLICATION ................................................................................... 2

2 DESCRIPTION (FIG A) ...................................................................... 2

3 PACKAGE CONTENT LIST .............................................................. 2

4 GENERAL POWER TOOL SAFETY WARNINGS ............................ 2

5 BEFORE START-UP, NOTE THE FOLLOWING! ............................. 3

6 INSTALLATION ................................................................................. 3

7 SETTING TO WORK .......................................................................... 4

7.1 Venting the pump before use ................................................................................... 4

7.2 Setting the ON/OFF operating point ......................................................................... 4

8 CLEANING AND MAINTENANCE .................................................... 4

8.1 Maintenance guidelines ............................................................................................ 4

8.2 Cleaning the impeller ................................................................................................ 5

9 TECHNICAL DATA ............................................................................ 5

10 SERVICE DEPARTMENT .................................................................. 5

11 TROUBLESHOOTING ....................................................................... 6

12 STORAGE .......................................................................................... 6

13 WARRANTY ....................................................................................... 6

14 ENVIRONMENT ................................................................................. 7

15 DECLARATION OF CONFORMITY .................................................. 8

Summary of content (8 pages)

PAGE 1
POW67915 EN 1 APPLICATION ................................................................................... 2 2 DESCRIPTION (FIG A) ...................................................................... 2 3 PACKAGE CONTENT LIST .............................................................. 2 4 GENERAL POWER TOOL SAFETY WARNINGS ............................ 2 5 BEFORE START-UP, NOTE THE FOLLOWING! ............................. 3 6 INSTALLATION ..................................................
PAGE 2
EN POW67915 SUBMERSIBLE PUMP 900W POW67915 1 APPLICATION This pump is used primarily as cellar pump. When installed in a shaft, the pump provides protection from flooding. It is also used wherever water has to be moved from one place to another, e.g. in the home, agriculture, horticulture, plumbing and many other applications. It is not designed for commercial use. WARNING! Read this manual and general safety instructions carefully before using the appliance, for your own safety.
PAGE 3
POW67915 EN 5 BEFORE START-UP, NOTE THE FOLLOWING!  The pump can be connected to any shock-proof plug which has been installed according to regulations. The plug must have a supply voltage of 230 V ~ 50 Hz. Fuse min. 6 Amp. Caution! When the pump is to be used near swimming pools or garden ponds and in their area of protection, it must be equipped with a PRCD (residual current circuit breaker) with a nominal trip current of max. 30 mA (according to VDE 0100, part 702 and 738).
PAGE 4
EN POW67915 Important Note! If the mains cable or plug suffers any damage from external action, repairs to the cable should be serviced by a qualified specialist using only standard spare parts. This will ensure that it meets the required safety standards. 7 SETTING TO WORK After having read these instructions carefully, you can set your pump to work, reconsidering the following:  Check if the pump rests on the ground of the shaft.  Check of pressure cord has been attached properly.
PAGE 5
POW67915 EN Important ! Note! Remove the mains plug before all maintenance work.      When the pump is often transported in the course of operation, it should be cleaned out with clear water after every use. In case of stationary installation, the function of the bating switch should be checked every 3 months. All fibrous particles which may have built-up inside the pump housing should be removed with a water jet. Every 3 months the shaft ground and as should be cleaned from mud.
PAGE 6
EN POW67915 11 TROUBLESHOOTING Incidents Pump does not start Causes No mains supply Floater does not switch No flow Inlet sieve is clogged Pressure hose in bent Pump does not switch off - Floater cannot sink down Insufficient flow Pump switches off after short operating period Remedies Check mains supply Bring floater in a higher position Clean inlet sieve water jet Reset hose - Place pump properly on shaft ground Inlet sieve is clogged Clean inlet sieve Reduced pumping Clean pump and replace capacity b
PAGE 7
POW67915       EN Definitely excluded from the warranty is damage resulting from fluid permeation, excessive dust penetration, intentional damage (on purpose or by gross carelessness), inappropriate usage (use for purposes for which the device is not suitable), incompetent usage (e.g. not following the instructions given in the manual), inexpert assembly, lightning strike, erroneus net voltage. This list is not exhaustive.
PAGE 8
EN POW67915 15 DECLARATION OF CONFORMITY VARO N.V. - Joseph Van Instraat 9 - BE2500 Lier - BELGIUM, declares that, Product: SUBMERSIBLE PUMP 900W Trade mark: POWERplus Model: POW67915 is in conformity with the essential requirements and other relevant provisions of the applicable European Directives, based on the application of European harmonized standards. Any unauthorized modification of the apparatus voids this declaration.