Operation Manual

POW751 EN
Copyright © 2016 VARO P a g e | 6 www.varo.com
 BEWARE OF ANY HAZARD - Beware of any Hazard by the material being sprayed and
consult the markings on the container or the information sup- plied by the manufacturer.
 DO NOT SPRAY - Do not spray any material where the hazard is not known.
 USE EYE PROTECTION - Always use appropriate eye protection to keep hazardous
vapors or fumes out of the eyes.
 WEAR A MASK - Never operate a spray gun without wearing a face mask
 PROTECT YOUR EARS - Wear ear protectors if the sound pressure exceeds 85 dB(A).
 MAINTAIN YOUR TOOLS - Keep your spray gun，paint container and nozzles clean. Do
not clean with flammable liquids with a flash point less than 32 °C。Inspect the mains lead
periodically and if damaged have it replaced by a qualified person.
 NAKED FLAMES - Never spray near a naked flame or appliance pilot flame.
 SMOKING - Never smoke whilst spraying.
 THINNING - Always read the paint manufacturers thinning recommendations or
instructions before using paint or other materials.
 DISCONNECT FROM THE NAINS SUPPLY - Always disconnect from the mains supply
when filling the paint container or cleaning the spray gun.
 SWITCH OFF WHEN NOT SPRAYING – Avoid running the unit with the flow rate knob
fully closed for any length of time.
We accept no responsibility for damage caused by the use of unsuitable
substances, or paints that have not been thinned correctly, and any health
hazards that arise from lack of adequate ventilation
5.1 Immediately switch off the spray gun when :
 Interruption in the mains plug, mains lead or mains lead damage.
 Defect switch.
 Smoke or stench of scorched isolation.
6 OPERATION INSTRUCTIONS
6.1 Preparation (fig b.)
Do not use textured wall paints or coatings as this will block the nozzle.
To obtain the best results, it is important that you prepare the surface to be sprayed and thin
the paint to the correct viscosity, before you operate your spray gun. Always ensure that the
surfaces to be sprayed are free from dust, dirt and grease. Make sure that you have masked
the areas that should not be sprayed, using a good quality masking tape. The paint or fluid to
be sprayed should be thoroughly mixed and free from lumps or other particles. Many
substances can be sprayed with your spray gun, but always check the manufacturers
recommendations before purchasing your paint.