Operation Manual

ManualsBrandsPowerplus ManualsOtherPOW910

POW910 EN

1 APPLICATION .................................................................................. 2

2 DESCRIPTION ................................................................................. 2

3 SYMBOLS ........................................................................................ 2

4 SAFETY WARNINGS ....................................................................... 2

5 ASSEMBLY (FIG. A) ........................................................................ 2

6 USE ................................................................................................... 3

7 INSPECTION AND MAINTENANCE ............................................... 3

8 TECHNICAL DATA .......................................................................... 3

9 ENVIRONMENT ............................................................................... 4

10 DECLARATION OF CONFORMITY ................................................ 4

Summary of content (4 pages)

PAGE 1
POW910 EN 1 APPLICATION.................................................................................. 2 2 DESCRIPTION ................................................................................. 2 3 SYMBOLS ........................................................................................ 2 4 SAFETY WARNINGS ....................................................................... 2 5 ASSEMBLY (FIG. A) ........................................................................
PAGE 2
EN POW910 PIVOTING ARM FOR HOIST POW910 1 APPLICATION The pivoting arm is designed to have one hoist attached to it. The pivoting arm must be mounted on a well-attached steel rod for this purpose, which has a diameter of 48 mm. 2 DESCRIPTION 1. 2. 3. 4. 5. 6. Bottom support Clamping block 2 bolts (M12 x 60 mm) Upper support Supporting arm Cotter pin 7. 8. 9. 10. 11. 12.
PAGE 3
POW910 § § EN Hook the lower pivoting arm (7) on the hinge pin of the lower support and secure it by putting a large cotter pin (8) through the hole of the pin. Attach the loose part of the support arm (5) to the lower pivoting arm (7) by using an M12 x 70 mm bolt (10), an M12 nut, a Ø 12 mm spring washer and a Ø 12 mm flat washer (pos. B). 6 USE § § § § § § § § § Before being taken into use, all components must be inspected. The vertical support pillar must be robust.
PAGE 4
EN POW910 9 ENVIRONMENT Should your appliance need replacement after extended use, do not dispose of it with the household refuse, but in an environmentally safe way. Waste produced by electrical machine items should not be handled like normal household rubbish. Please recycle where recycle facilities exist. Check with your Local Authority or retailer for recycling advice. 10 DECLARATION OF CONFORMITY VARO N.V.