Operation Manual

POWDP9010 EN

 In case of skin or eye contact, follow the instructions below:

✓ Immediately rinse with water. Neutralize with a mild acid such as lemon juice or

vinegar.

✓ In case of eye contact, rinse abundantly with clean water for at least 10 minutes.

Consult a physician.

Fire hazard! Avoid short-circuiting the contacts of a detached battery. Do not

incinerate the battery.

7 CHARGING AND INSERTION OR REMOVAL OF BATTERY

7.1 Charger indications

Connect the charger to the power oulet socket

▪ Solid green: ready to charge

▪ Flickering red: charging

▪ Solid green: charged

▪ Solid green and red: battery or charger damaged

Note: if the battery does not fit properly, disconnect it and confirm that the

battery pack is the correct model for this charger as shown on the

specification chart. Do not charge any other battery pack or any battery pack

that does not securely fit the charger.

1. Frequently monitor the charger and battery pack while connected

2. Unplug the charger and disconnect it from the battery pack when finished.

3. Allow the battery pack to cool completely before using it.

4. Store the charger and battery pack indoors, out of reach of children.

NOTE: If battery is hot after continuous use in the tool, allow it to cool down

to room temperature before charging. This will extend the life of your

batteries.

7.2 Removal / insertion of battery (Fig. 1)

WARNING: Before making any adjustments ensure the tool is switched off or

remove the battery pack.

▪ To install: push and slide battery pack into battery port, make sure the release latch on the

rear side of the battery snaps into place and battery is secure before beginning operation.

▪ To remove: Press the battery release latch and pull the battery pack out at the same time.

7.3 Battery capacity indicator

There are battery capacity indicators (2) on the battery pack, you can check the capacity status

of the battery if you squeeze the button (3). Before using the machine, please press switch

trigger to check if the battery is full enough for properly working.

Those 3 LED might show the status of the capacity level of the battery:

▪ 3 LED’s are litt: Battery fully charged

▪ 2 LED’s are litt: Battery 60% charged

▪ 1 LED is litt: Battery almost discharged