Operation Manual

POWE40030 EN
Copyright © 2017 VARO P a g e | 6 www.varo.com
Note: All orbital sanders leave sanding marks on the workpiece. To
minimize sanding marks, always try to sand with the grain of the wood.
 Occasionally check the sandpaper for tears, wear, or fraying. Replace if necessary.
 When you are finished, turn off the switch.
 Allow the tool to come to a complete stop before setting it down.
 To prevent accidents, turn off the tool and disconnect its power supply after use. Clean
and then store the tool indoors out of children’s reach.
9 TECHNICAL DATA
Rated voltage
230 V
Rated frequency
50 Hz
Rated power
450 W
Rotation sped
6000-13000 min
-1
Disc diameter
125 mm
Cable length
2 m
Carbon brush motor
Yes
Oscillation speed
12000-26000min
-1
Electronic speed control
Yes
Soft grip
Yes
Hook & loop system
Yes
Self-dust function
Yes
Power on LED light
Yes
10 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
80 dB(A)
Acoustic power level LwA
91 dB(A)
ATTENTION! Wear hearing protection when sound pressure is
over 85 dB(A).
aw (Vibration)
5.6m/s²
K = 1.5 m/s²
11 CLEANING AND MAINTENANCE
Attention! Before performing any work on the equipment, pull the power
plug.
11.1 Cleaning
 Keep the ventilation slots of the machine clean to prevent overheating of the engine.
 Regularly clean the machine housing with a soft cloth, preferably after each use.
 Keep the ventilation slots free from dust and dirt.
 If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.