Operation Manual

POWE80010 EN

7.3 Fitting the auxiliary handle (Fig. 3)

WARNING: Prior to assembly and adjustment always switch off the tool and

pull out the power plug from the mains socket.

The auxiliary handle (3) can be attached to the multi-purpose in two different mounting holes:

left and right.

8 OPERATION

8.1 Switching ON/OFF (Fig. 4)

First check that the cable and plug are not damaged.

 Connect the plug to the power supply. The power-on indicator (5) is illumed until the tool

disconnect from the power mains.

 Switching the power tool ON: slide ON/OFF switch button (4) forward onto position (I).

 Switching the power tool OFF: slide ON/OFF switch button backward onto position (O).

8.2 Speed adjusting (Fig. 5)

The tool can be set at 6-speed adjustment positions. The "1" position indicates the lowest and

the "6" position indicates the highest speed, you can adjust different speed by turning the

speed control dial (10) from "1" to "6" position. The operator may have to vary the speed to

optimize working efficiency.

8.3 Application tips

8.3.1 Selecting the Application Tool/Accessory

Accessory

Material

Plunge cut saw blade wood

Wooden materials, plastic,

gypsum and other soft materials.

Segment saw blade with recess

Wooden materials and plastic.

Shovel blade

Wood, paint, carpet adhesive,

silicone and other elastic

materials.