User Manual

POWLI211 EN

 The power is to be turned off before mounting the LED floodlight with sensor.

 The fitting is to be mounted in such a way that the angle of inclination of the

longitudinal shaft of the lamp (burning position) is less than 4° with respect to the

ground area.

 Secure the fitting with two screws or bolts, out of reach and at a minimum height of

2.5m.

 The grounding wire (yellow/green) of the connection cable must be connected to the

connection terminal, indicated with grounding symbol. The power wires are to be

fitted in the connection block.

 Secure the sealing rubber to guarantee the spatter resistance, and ensure that all

mounting screws are properly fastened.

 Installation height of this lamp should be minimum 2.5m.

5 WIRING DIAGRAM (FIG. 2)

Fix the wiring in the connection block according to the included diagram (Fig. 2):

a=brown conductor of the network cable (L)

b=blue conductor power cable (N)

c=yellow/green: grounding cable

d=control (red)

6 USING THE FLOODLIGHT

 Simply plug in the cable of the floodlight to the socket.

7 SETTING THE LIGHT SYSTEM (FIG. 3)

7.1 Test mode

 Turn the LITE control and the Time control anticlockwise to the edge (the TEST

position).

 Set the SENS. Control to its mid-point.

 Turn on the wall switch. The floodlight will turn on for about 1 minute to warm up.

Then it turns off.

 Walk through the detection area. The floodlight turns on when you move and turns off

when you stop. Wait for the floodlight to turn off before moving again to test the

sensor.

 Adjust the motion sensor to cover the desired detection area.

 For a smaller coverage area, point the sensor down; for a larger coverage area, point

the sensor up.

7.2 TIME adjustment

 The TIME adjustment controls how long the floodlight will stay on after the motion

has been detected.

 Turn the TIME control knob clockwise to increase (up to about 12 minutes) how long

the floodlights stay on or anti-clockwise to decrease (down to about 5 seconds) the

time delay.