User Manual

POWLI013 EN

PORTABLE HALOGEN FLOODLIGHT 150W

POWLI013

1 DOMAIN OF USAGE

Outdoor or indoor usage such as jobsite, garden, studio and workshop.

WARNING! Read this manual and general safety instructions

carefully before using the appliance, for your own safety. Your

power tool should only be passed on together with these

instructions.

2 SYMBOLS

In this manual and/or on the machine the following symbols are used:

Read the manual before using the machine

In accordance with essential applicable safety standards of European

directives

3 WARNING

 Never attempt to change wire connection way as this has been fixed professionally.

 The lighting fixture shall be fixed on stand vertically that the longitudinal axis does not

slant than ±4°from the ground plate.

 Disconnect the plug (all-poles) from the network when the front glass is open, and

follow the instructions to the next step

 Do not put the lamp any closer than 0.8 m to any object.

 Replace before using the shielding glass if it is damaged.

 If the external flexible cable or cord of this luminary is damaged, it shall be

exclusively replaced by the manufacturer or his service agent or a similar qualified

person in order to avoid a hazard.

4 ASSEMBLYING LAMP ONTO THE STAND

 First unscrew the black wing-nut (C).

 Slide the G-shaped tubular base (D) into black metal clamp at base of the lamp.

Assemble with the wing-nut through the slot in the black metal clamp.

 By loosening the wing-nut (C), you can tilt the lamp into the desired angle.

 Lock the lamp in place by tightening the wing-nut.

PAGE 1
POWLI013 EN PORTABLE HALOGEN FLOODLIGHT 150W POWLI013 1 DOMAIN OF USAGE Outdoor or indoor usage such as jobsite, garden, studio and workshop. WARNING! Read this manual and general safety instructions carefully before using the appliance, for your own safety. Your power tool should only be passed on together with these instructions.
PAGE 2
POWLI013 EN 5 USING THE FLOODLIGHT  Simply plug in the cable (E) of the floodlight to the socket. 6 FIXING AND CHANGING A HALOGEN TUBE     Switch off lamp before installing the bulb. Remove screw (A) on top of the lamp and open the cover. Push the bulb (B) in between the two prongs. Make sure the prongs are centered on the metal tips of the bulb, not the ceramic casing. To avoid premature burn out of the halogen bulb, It is essential to avoid contact with bare fingers.