Operation Manual

POWP2050 EN
Copyright © 2018 VARO P a g e | 6 www.varo.com
▪ For masonry, such as brick, cinder block, cemetery, etc, use carbide tipped drill bits.
▪ Use enough pressure to keep the bit biting but do not push so hard that do not stall the
motor or damage the bit.
▪ Always apply pressure in a straight line with the bit.
▪ Hold the drill firmly to control the twisting of the drill.
Warning：If the drill stalls, release the trigger immediately, remove the drill
from the work and determine the cause of the stalling. Do not click the switch
on and off as this can damage the motor.
▪ To minimize the chance of stalling and breaking through the material, reduce the pressure
on the drill and ease the bit through the last part of the hole.
▪ Keep the motor running when pulling the bit back out of a drilled hole. This will help
prevent jamming.
8 MAINTENANCE
Do not attempt to make any adjustments while the tool is in operation.
Clean out any accumulated dust with a brush or dry cloth.
Do not allow petroleum-based products to come into contact with plastic parts as they contain
chemicals, which could damage, weaken or destroy plastic.
9 TECHNICAL DATA
Mains voltage
230-240V ~ 50Hz
Power input
1050W
No load speed
0-1100 / 0-3000 min-1
Chuck capacity
13mm
Double isolation
Yes
Impact rate
0-16500/ 0-45000 min
-1
Max. drill capacity
Wood
40 mm
Steel
13 mm
Concrete
16 mm
10 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
95 dB(A)
Acoustic power level LwA
106 dB(A)
ATTENTION! Wear hearing protection when sound pressure is
over 85 dB(A).
aw (Vibration)
9 m/s²
K = 1,5 m/s²
11 ENVIRONMENT
Should your appliance need replacement after extended use, do not discard it with
the household rubbish but dispose of it in an environmentally safe way.
Waste produced by electrical machine items should not be handled like normal
household rubbish. Please recycle where recycle facilities exist. Check with your
Local Authority or retailer for recycling advice.