Operation Manual

POWX0260 EN

7 OPERATION

WARNING: Prior to assembly and adjustment always pull out the power plug

from the mains socket.

7.1 Changing drill or screwdriver bit

▪ Insert the chuck key in one of the three holes on the side of the chuck (1), turn to open.

▪ Insert the desired drill or screwdriver bit in the chuck and turn the chuck key the opposite

way until the chuck has a firm grip on the drill or screwdriver bit.

▪ Check that the drill or screwdriver bit is in the centre of the chuck and is secure.

7.2 Switching on/off (Fig. 1)

▪ Plug the cord set into power socket.

▪ Start the tool by squeezing the ON/OFF switch (8).

▪ Release the ON/OFF switch to stop the tool.

▪ If you press the lock-on button (7) while the ON/OFF switch is depressed, the ON/OFF

switch is kept in the operating position.

▪ To release the ON/OFF switch (8) and turn the tool off.

7.3 Forward/reverse lever (Fig. 2)

▪ The forward/reverse lever (5) is to determine the rotation direction of the chuck.

▪ To select forward rotation, release the ON/OFF switch (8) and push the forward/reverse

lever to right (R) side of the tool. To select reverse rotation, push the lever to left (L) side

of the tool.

NOTE: When changing the position of the lever, be sure the ON/OFF switch

is released and the motor is stationary.

7.4 Variable speed (Fig. 3)

This tool has a speed control dial (6) that delivers higher speed by turning to the “+” direction,

and delivers lower speed by turning to “-”direction.

7.5 Drill or impact mode selector (Fig. 4)

The drill and impact mode selector is on the top of this impact drill.

▪ Push the button of drill /impact mode selector (4) to the “ ” to select the impact mode of

action.

▪ Push the button of drill/impact mode selector to the drill position “ ” to select the drill mode

of action.