Operation Manual

POWX0273 EN
Copyright © 2016 VARO P a g e | 6 www.varo.com
Always use ear-protection, when machine is in use!
Recommended nominal operating-time: approx. 20 minutes under
permanent load.
Rest after permanent operation: approx. 5-10 minutes.
7 ASSEMBLY
Disconnect the power plug before carrying out any adjustments or
maintenance.
7.1 Inserting bit or drill (Fig. 1)
 Open the chuck (1).
 Insert the drill or bit in the chuck.
 Tighten the chuck firmly.
Check if the bit or drill is in the centre of the chuck.
7.2 Auxiliary handle (Fig. 2)
The auxiliary handle (8) will provide additional control, support and guidance for the drill.
 Slide the holder of the side grip over the drill chuck on the machine.
 Turn the side grip in the required position and tighten it firmly.
7.3 Depth gauge (Fig. 3)
The depth stop is used to limited the maximum drilling depth.
 Loosen the side grip (8).
 Insert the depth stop (2) in the hole in the holder of the side grip.
 Adjust the depth stop to the required drilling depth.
 Tighten the side grip firmly.
8 OPERATION
8.1 Selecting the operation mode (Fig. 4)
The drill and impact mode selector is on the top of this impact drill.
 Push the button of drill /impact mode selector (3) to the “ ” to select the impact mode of
action.
 Push the button of drill/impact mode selector to the drill position “ ” to select the drill mode
of action.
8.2 Forward / reverse lever (Fig. 5)
 The forward/reverse lever (7) is to determine the rotation direction of the chuck.
 To select forward rotation, release the ON/OFF switch (4) and push the forward/reverse
lever to right (R) side of the tool. To select reverse rotation, push the lever to left (L) side
of the tool.
NOTE: When changing the position of the lever, be sure the ON/OFF switch
is released and the motor is stationary.
8.3 Variable speed (Fig. 6)
This tool has a speed control dial (6) that delivers higher speed by turning to the “+” position
and delivers lower speed by turning to the “-“ position.